'And what did it show up as when you tried again? When you ran the Zadig software to do the driver swap, did it find the device?' 'And at this point did it see it as a REALTEK 2832U device, or as a keyboard?' One of the other folders I believed was for the IR remote. When running the SDR# software (with the device set to RTL-SDR (USB)) I just get an error window: Device Not found.Īre there any files on the supplied CD that are useful? I viewed it and Also tried one of the install.exe files from a folder I suspected would be for the SDR stick. I have also tried using another piece of SDR software.also no success. and if so, where would I locate it?Īt one point try to troubleshoot, I also ran CrapCleaner to remove drivers (after removing the device in Device Manager), reboot of computer, reinserting the SDR followed by a reinstall and driver fix. I initially plugged it into a powered USB multiple port, and also tried it in a solitary USB 3.0 port.Ĭould I try to locate the appropriate WinUSB driver in Device Manager for the SDR device?. I also tried 'remove device' and after a reboot, reinserted it where after a few seconds it recognized the device.but again as a HID keyboard. Any assistance would be greatly appreciated.Ģ- No success from the driver fix (which was one of the same steps also on the SDR# website)ģ- When I initially plugged the SDR into the USB port I do believe it did see it. I have also looked at the files and do not know what, and if any files I should run to find a solution to my problem. The computer store (MicroCenter) where I purchased the SDRs also supplied a CD. I believe that the problem I am currently experiencing with Windows 10, is that the computer 'sees' the SDR as a keyboard (HID device). I had to download and install the Zadig V2.3 to be able to install the WinUSB driver for Bulk In, Interface 0 successfully. I also did not have initial success with the version of Zadig that was installed via running the install-rtlsdr.bat file. (I did have some problems with the SDR# steps for downloading the RelWithDebInfo.zip file: the install-rtlsdr.bat did not fully load the file, I ended up finding the file on the Osmocom website and have placed it in the appropriate directory (which is also not a read-only folder and is not in the Program Files folder). This also included the steps for the driver update/replace.

I have followed the directions on the Adafruit/ and also the SDR# website on installing the software for the SDR. I have as of yet been unable to get the SDR to work properly. Hello, I recently purchased (2) RTL-SDR 2832U ( ).

Rtl sdr zadig windows 10